VRP Series VRP-1000 VRP-1200 USER’S MANUAL Home Theater Subwoofer Vel odyn e
Caution IMPORTANT SAFETY INSTRUCTIONS A Ati Caution To reduce the risk of electric shock, do not remove cover (or back). No user-serviceable parts inside. Refer servicing to qualified service personnel. The lightning flash with arrowhead symbol is intended to alert the user to the presence of uninsulated "dangerous voltage" wnhin the product's enclosure that may be of sufficient magnitude to constitute a risk of electric shock to persons.
Ta b l e o f C o n t e n t s Congratulations . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .1 Installation . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .2 Rear Panel Connections . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .5 Crossovers . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Congratulations Congratulations on your purchase of a Velodyne Rear Port (VRP™) subwoofer system. This system represents the state-of-the-art in home audio reproduction and will provide you with years of listening pleasure when properly cared for. Read and follow this instruction manual to insure safe and proper system connection and operation. Caution! Please observe the following instructions to insure safe and proper system operation.
Placement True subwoofers operate at extremely low frequencies that are primarily omni-directional. Keep in mind that frequency response and output level can be drastically influenced by placement, depending on the acoustic properties of the listening room. Typically, the optimum location for a subwoofer is tucked away in a corner of your listening room. This location will usually offer the greatest output levels and optimum low frequency extension.
To alleviate this condition, we recommend the following steps: 1) If using line level jacks, BOTH THE LEFT AND RIGHT INPUT SHOULD ALWAYS BE USED – never use just the left or just the right input. If the subwoofer’s input comes from the LFE channel of your receiver, use the included “Y” splitter to divide the single input into two inputs for the Left and Right subwoofer inputs.
Phase Adjustment - 0°/180° This control allows you to “reverse” the phase of the subwoofer’s output signal 180° to correct for any possible mismatch and resulting cancellation between the subwoofer and your main speakers/amplifier. To adjust, simply listen to the system with music playing, then depress the phase switch from one position to the other and listen for a change in low frequency output. The correct position will have a greater amount of apparent low frequency output.
R e a r Pa n e l C o n n e c t i o n s Figure 1.VRP Rear Panel Connections Figure 1 shows the connections on the rear panel of the VRP. Following are brief descriptions of the connections described in Figure 1. More detail of these connections can be found below: . (1) SPEAKER LEVEL INPUT terminals - Connect these input terminals to the speaker output terminals of your amplifier or receiver.
(5) Power indicator - Red: Unit is in standby mode. Green: Unit is in operation mode. (automatically turns to STANDBY mode if no signal for eight minutes) (6) PHASE switch - Select the switch position at which you hear a louder bass sound. (7) VOLUME LEVEL knob - Use this knob to adjust the output level of the subwoofer. C ro s s ov e rs Receiver/Processor Subwoofer Outputs The Velodyne subwoofer is designed to operate using the full range audio signal for input when using the built-in crossover.
+R- -L+ REAR o o 000 000 FRONT SUBWOOFER OUTPUT JACK AMPLIFIER LOW -PASS CROSSOVER + SPEAKER LEVEL R L • "'" • :.0.: ~;~O:'i La + 50Hz 200Hz SUBWOOFER INPlIT o o o o o 0 0 0 VOLUME :0::.x Cl)PH~ • DODD OUTPUT + R - - L MI: + ::~. LLFEIN Velodyne c@us U5JB) VRP Series (AUDIO APP ARA TUSI 68BM E203436 SERIAL # LABEL VELODYNE ACOUSTICS, INC. AVIS: RISQU: DE (HOC a.ECT1IlQUE-IIE PAS OUVRIR oawmooo _ _ lOJ. . :DWJ ......... CYIEODL......,...,-1'MII MORGAN HILL. CA.
+RREAR o -L+ 0 0 0 SUBWOOFER OUTPUT JACK AMPLIFIER FRONT .. LOW -PASS CIIOSSCNER • "' • SPE + =:i :.©.: RLEV R."~,.""'.., INPUT OUTPUT L to"", ""'" SUBWOOFER :e~": :.0.: • ",.S> MIN ~,. -'" _180' MAX Velodyne VRP Series SERIAL *LABEL VELODVNE ACOUSTIcs. MORGAN HIli. CA. INC. SUBWOOFER + REAR PANEL + RIGHT FRONT SPEAKER LEFT FRONT SPEAKER RIGHT FRONT SPEAKER, LEFT FRONT SPEAKER . Figure 2b. Speaker-Level Subwoofer Connection Diagram www.velodyne.
Interconnect Cables When installing your new Velodyne subwoofer using the line level connections, you should always use shielded phono cables. There are many high quality cables available today. It is recommended that you keep the length of cable as short as possible to avoid any potential noise problems. When using speaker level connections, use a high quality speaker cable that mates well with the connectors.
T roubleshooting and Service If you should experience a problem with the operation of your subwoofer, please check all of the following before seeking service. Following is a simple troubleshooting guide to assist you. 1. Verify that the unit is plugged in, the power outlet is active, and is supplying proper voltage. 2. Is unit receiving an input signal from your source? 3. Have all controls on subwoofer (volume, crossover, phase, etc.) been properly set? 4.
Specifications . SPECIFICATIONS VRP-1000 VRP-1200 Woofer 10” (24.5 cm) forward firing (8.2” piston diameter) 12” (30.5 cm) foward firing (9.
Other Velodyne Products: 110V DD™ Series DD-10 DD-12 DD-15 DD-18 Digital Drive 1812 Signature Edition DLS™-R Series DLS-3500R DLS-3750R DLS-4000R DLS-5000R DPS™ Series DPS-10 DPS-12 230V MiniVee™ SMS™-1 SPL™-R Series SPL-800R SPL-1000R SPL-1200R SPL-1500R SubContrator™ Series SC-1250 SC-8 SC-10 SC-12 SC-15 SC-IW SC-IF SC-IC DD™ Series SMS™ -1 DD-10 DD-12 DD-15 DD-18 Digital Drive 1812 Signature Edition CHT-R Series CHT-8R CHT-10R CHT-12R CHT-15R SPL-800i SPL™-R Series SPL-800R SPL-1000R SPL-1200R SPL
FOR YOUR RECORDS. . . Date Puchased_________________________________________________________________ Dealer_________________________________________________________________________ Serial #________________________________________________________________________ *NOTE: Please complete and return your warranty card within ten (10) days or Register. . . ON LINE . . . It’s faster . . . and easier www.velodyne.com LIMITED WARRANTY VELODYNE ACOUSTICS, Inc.
Velodyne Acoustics, Inc. 345 Digital Drive Morgan Hill, CA 95037 408.465.2800 voice 408.779.9227 fax 408.779.9208 service fax www.velodyne.com Service E-mail: service@velodyne.com Product E-mail: help@velodyne.com Technical E-mail: techhelp@velodyne.com . 63-VRP1012 Rev B JUL06 www.velodyne.