User's Manual
8 VELUX VELUX 9
Menu
Locate
Register Info
P1
P2
P1
P2
Enter
P1
P2
ENGLISH ENGLISH
Initial set-up
5
Press "Register" to start registration.
6
Registration is running. This can take up to two minutes.
7
The display shows "Completed" when all products have
been registered.
Note: If the display shows "Failed", remove the batteries
from the remote control. Prepare the products for registra-
tion, see section Resetting and preparing for registration.
Repeat the initial set-up.
8
The display shows one of the registered products.
Press
to see the other registered products.
For use of more than one remote control, all products must
be registered in one of the remote controls, see above.
Then the information must be copied from this remote
control to the other remote controls, see section Using
additional activation controls.
Note: The opening of the skylight operator must be
adjusted if your skylight is positioned within reach, see
section Adjusting the opening.
Products to be operated with the remote control must be
registered in the remote control. Registration, however,
depends on whether the remote control is new or whether
it is already used for operating other products.
1
• If the remote control is already in operation, proceed
with section Registering new products.
• If the remote control is new, proceed as follows.
When the initial set-up has been completed, the registered
products will appear in the display.
2
Slide o the battery cover of remote control as shown.
Insert the three batteries supplied (type AA, 1.5 volt).
Replace cover.
3
Choose language:
Press
to highlight your language.
Press "Enter" to confirm your choice.
4
Prepare products for registration.
Disconnect the main power supply to the products for
1 minute and then reconnect it. The products can now be
registered in the remote control within the next 10 min-
utes.