User's Guide

O
INT
1
1
1
2
2
2
VELUX INTEGRA
®
KLR 200
VELUX 39
Centre-pivot windows
1
Open window manually (if the window is already open, close it
by pressing the test button on the window operator).
2
Press the test button on the window operator for at least
10 seconds.
The window operator and other electrical products on the
window will run briefly back and forth. Frame lights, if installed,
will flash briefly.
Flat roof windows
1
Carefully remove the cover cap on the kerb.
2
Press the test button on the window operator behind the cover
cap for at least 10 seconds.
The window operator and other electrical products on the
window will run briefly back and forth. Refit cover cap.
Modular skylights
1
Remove bottom flashing section from the modular skylight and
unscrew the small, right-hand cover of the control unit.
2
Press the reset button in the control unit for 6-10 seconds.
Screw on the cover again and refit bottom flashing section.
Note: As registration in the control pad must take place within
10 minutes, you are advised to register the products before refit-
ting bottom flashing section.
If the initial set-up fails
If the control pad cannot find some of the products, you can make the products ready for registration by manually resetting them to their
initial factory settings.
Note: Reset products cannot be operated until they have been registered in the control pad. See the section Initial set-up.
Products can be reset in different ways, depending on window type.
Note: Contact your local VELUX sales company for reset of products not shown.
Setting up
Start-up of a new VELUX INTEGRA
®
system
3