User's Manual

2 VELUX VELUX 3
ENGLISH:
IMPORTANT INFORMATION
WARNING – TO REDUCE THE
RISK OF SEVERE INJURY OR
DEATH:
Safety
• Read instructions carefully before installing and operating.
• Please keep instructions for future reference and hand them over to any new user.
• To avoid sparks from the accessory wires during connection to the low voltage
system (24 V), disconnect skylight or control unit KLC 500 from main power
supply and, if installed, battery backup KLB 100.
• This device is not intended for use by persons (including children) with reduced
physical, sensory or mental capabilities, or lack of experience and knowledge,
unless they have been given supervision or instruction concerning use of the
device by a person responsible for their safety.
• Children should be supervised to ensure that they do not play with the device.
• Never let children play with the product or the remote control. The remote con-
trol should be kept out of reach of children at a minimum height of 5 feet (1.5 m).
• The product must not be put into operation until it has been fitted according to
these instructions.
• Before operating, ensure that the product can be and is operated without risk of
damage to property or injury to people or animals.
• If repair and adjustment work is needed, disconnect from the main power supply
and ensure that it cannot be reconnected unintentionally.
• The product must not be covered (maximum casing temperature: 122°F/50°C).
• This product has been designed for use with genuine VELUX products. Connec-
tion to or use with other products may cause damage, malfunction or injury.
• The product has a Class 2 Low Voltage input (19-24 V d.c.).
• Disconnect from the main power supply before carrying out any maintenance,
repair, adjustment or service work to the skylight or products connected to it
(including control unit KLC 500 and, if installed, battery backup KLB 100) and
ensure that it cannot be reconnected unintentionally during this time.
• The product requires a minimal amount of maintenance. The surface may be
cleaned with a soft, damp cloth using a small amount of household cleaner
diluted in water.
• This device complies with part 15 of the FCC and RSS-210 of the IC rules. Oper-
ation is subject to the following two conditions: (1) This device may not cause
harmful interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation.
• This device has been tested and found to comply with the limits for a Class B
digital device, pursuant to part 15 of the FCC Rules. These limits are designed
to provide reasonable protection against harmful interference in a residential
installation. This device generates, uses and can radiate radio frequency energy
and, if not installed and used in accordance with the instructions, may cause
harmful interference to radio communications. However, there is no guarantee
that interference will not occur in a particular installation. If this device does
cause harmful interference to radio or television reception, which can be deter-
mined by turning the device off and on, the user is encouraged to try to correct
the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the device and receiver.
- Connect the device into an outlet on a circuit different from that to which the
receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
Changes or modifications not expressly approved by the party responsible for
compliance could void the user's authority to operate the device.
• FCC Radiation Exposure Statement:
This device complies with FCC RF radiation exposure limits set forth for an
uncontrolled environment.
• The term "IC:" before the device certification number only signifies that the
Industry Canada technical specifications were met.
• If you have any technical questions, please contact your VELUX sales company, see
telephone list or www.velux.com.
Installation
• The product is for indoor use only.
• Installation in rooms with a high level of humidity and with hidden wiring must
comply with relevant regulations (contact a qualified electrician if necessary).