Operating Guide

26 VELUX
®
VELUX
®
27
10 sec
KLC 500
1 sec
1
2
3
max 3 sec
Set-up of KLI 310/311/312 to operate products connected to
control unit KLC 500
Important: The wall switch must be the universal KLI 310 or the model
matching the product(s).
If a non-functional control must be replaced or if the wall switch cannot
find certain products, you can make the products ready for registration
by manually resetting them to initial factory settings.
Note: Reset products cannot be operated until they have been regis-
tered in the wall switch again.
1
The control unit can be reset by removing the cover and pressing the
test button for at least 10 seconds.
The connected products will run briefly back and forth in random
order to indicate that they are ready for registration.
2
Press the Pair button on the wall switch for 1 second.
3
Press the stop key and then the DOWN key within 3 seconds. This is
only necessary at the initial set-up after installing the product.
The products can now be operated by KLI 310/311/312.