Use and Care Manual
Cleaning your skylight as dirt appears will help prevent the use of scrapers.•
Interior cleaning
Most VELUX skylights have a white pre-painted, wood frame or maintenance free, ABS plastic frame and sash.•
These surfaces can be cleaned with a damp cloth.•
A mild, soapy water solution can be used for tougher dirt.•
Insect screens in venting skylights can be cleaned by removing the screen and spraying the screen with a garden hose.•
Let the insect screens thoroughly dry before replacing them into the skylights •
Interior finish
Pre-finished wood frames
Skylights with pre-finished wood frames need to be inspected annually. The finish that is applied to the wood surface is not
considered a permanent coating. As with any finished surface it is subject to peeling, cracking or fading and will need to be re-
finished/re-painted periodically.
To re-finish/re-paint the skylight interior wood surfaces, prepare the skylight by removing the factory finish. After ensuring that •
the surface is clean, apply primer to the wood. When primer is dry, apply a coat of water based acrylic varnish/paint (always
follow finish manufacturer’s application instructions).
For paint or finish damages to larger surfaces of the wood, apply the technique described above. •
Touch up paint for covering scratches to the wood surface is available from VELUX (part # 307408). •
Keep all varnish/paint o of skylight gaskets and glass.•
Unfinished wood frames
Skylights with an unfinished wood surface needs to be painted, stained or varnished within 6 months of installation. Failure to
finish bare wood can result in discolored wood, deterioration of the wood frame/sash and possibly lead to bowing and splitting of
the wood.
After ensuring that the wood surface is clean, apply stain or primer to the wood. When primer is dry, apply a coat of water •
based acrylic varnish/paint (always follow finish manufacturer’s application instructions).
Keep all stain and paint o of skylight gaskets and glass. •
It is not recommend to paint over abs (plastic) frames and sashes.
Exterior cleaning
Rain will keep most dirt and grime o of the exterior surfaces.•
The exterior cladding surfaces can be cleaned with a mild soapy water solution.•
Avoid using abrasive cleaners or cleaning equipment as this can scratch the finish on the cladding.•
Rinse well with clean water.•
Exterior inspection
Keep all debris removed from around skylights.•
Skylight applications with multiple skylights grouped together using gang flashing must have all vertical and horizontal gutters, •
between skylights, clear of dirt and debris.
Make sure all exposed fasteners are secure.•
Inspect cladding and flashing for excessive wear or scratches on the cladding finish.•
Scratches in the cladding finish may be fixed with touch up paint available through VELUX (part # ZOZ 154). −
Damaged claddings or flashings should be replaced as soon as they are detected. −