Use and Care Manual

Electric shades (hardwired shades)
are not able to be manually operated.
Issue: “My skylight shades are not fully
opening or closing.”
Resolution: You will need to recalibrate
the remote control and shades. Follow
the steps below.
• Check for and clear any obstructions
in the shade track.
• Press the UP/OPEN button on the
remote to take the shade to the top
position. Press the button again if
the shade is not fully open.
• On the shade, slide the power switch
to the OFF position and leave o for
30 seconds.
• Slide the power switch back to the
ON position.
• Within 30 seconds, on the remote
press the CENTER/STOP button
for 1 second and then the DOWN/
CLOSE button for 1 second.
• Cycle the shade to ensure it fully
opens and closes.
You can watch the instructional
video here.
Troubleshooting
your Remote
Control
Issue: “I need to close my skylight and my remote control
isn’t working.”
Resolution: You’ll need to manually close the skylight
with one of the three options below.
Option 1:
CLOSE THE SKYLIGHT BY TRIGGERING THE
RAIN SENSOR
• Solar unit: The rain sensor is the black pad located
next to the solar panel. Knock on the pad several
times with your knuckles or spray water on it
simulating raindrops. This sensor is acoustically
triggered.
• Electric units: Locate the rain sensor on either side
of the chain or externally mounted on the outside
frame. Spray water on it simulating rain drops
or wipe with a wet cloth. This sensor is moisture
triggered.
Option 2:
TRIGGER THE MOTOR TO CLOSE
THE SKYLIGHT
• For solar or electric units, first remove the insect
screen.
• Locate the button closest to the center of the
skylight (Button A in Fig. A). Insert a paperclip into
the hole and press button A for 1 second.
1 sec
A
1 sec
A
Figure A
04 Troubleshooting
12