Use and Care Manual

Issue: “My remote control is no longer
operating my skylight.”
Resolution: You’ll need to reset and
resynchronize your remote and skylight.
Follow the steps below based on your remote
and skylight types.
Step 1: Prep Your Skylight and Shades
a. Remove insect screen and ensure the
skylight unit has power
For electric skylights: Turn on circuit
breaker
For solar skylights (fig. b): Slide the switch
into the “on” position (see Fig. C).
b. Ensure skylight is closed by pressing the “A”
button with a straightened paper clip for
one second (see Fig. D).
1 sec
A
Figure C Figure D
Step 2: Resetting Skylights & Shades
Note: Complete Steps 2 & 3 with each
product, then repeat for multiple products.
Step 3 must be completed within 10
minutes of Step 2.
a. Reset the Skylight: Use a straightened
paper clip to press and hold the “A” button
for at least 10 seconds, then release the
button (see Fig. E). The skylight will run
briefly back and forth indicating it has
been reset. If no response is indicated,
angle the paper clip slightly to ensure
actuation of the reset button. This may
take multiple attempts.
10 sec
A
10 sec
A
Figure E
b. Resetting Skylight Shade:
For solar shade with sliding switch:
Slide switch to reset position (toward
skylight frame) and hold switch for at
least 10 seconds (see Fig. F). The shade
will begin to hum or move. Make sure to
continue holding the switch for the full
10 seconds.
For solar shade with concealed
button: Open the small door in the
center of the shade. The reset button
is centered inside this compartment
(see Fig. G). Press and hold the button
for at least 10 seconds. The shade will
begin to hum or move. Make sure to
continue holding the switch for the full
10 seconds.
10 sec
10 sec
Figure F Figure G
04 Troubleshooting
14