Installation Guide

12 VELUX
®
VELUX
®
13
B
2
1
3
L R
L R
1 sec
max 3 sec
Set-up of KLI 110 to operate VELUX INTEGRA
®
skylights VSE and
VCE
Option 1
1
Set up a single KLI 110 to control all skylights by disconnecting the
main power supply to the skylights for 1 minute and then reconnect
it.
Note: The skylights must now be registered in the control keypad within
the next 10 minutes.
2
Press button R on back of control keypad KLI 110 for 1 second.
3
Press the stop key and then the DOWN key within 3 seconds. This is
only necessary at the initial set-up after installing the skylights.
The skylights can now be operated by KLI 110.
Option 2
1
If several control keypads KLI 110 are needed to control separate sky-
lights on the same electrical circuit, determine which skylights should
be controlled as a group by each KLI 110. Register predetermined
skylight groups to a single KLI 110 by pressing the button closest to
the side frame on each of the skylights (B) once.
Note: The skylight group must now be registered in the control keypad
within the next 10 minutes.
2
Press button R on back of control keypad KLI 110 for 1 second.
3
Press the stop key and then the DOWN key within 3 seconds. This is
only necessary at the initial set-up after installing the skylights.
This skylight group can now be operated by KLI 110. Repeat to group
other skylights with other control keypads KLI 110.
If necessary, contact your VELUX sales company for additional as-
sistance.