Specifications

Signal flow 7
VeniceF
Operator Manual
Signal flow
The following table gives an overview of the basic signal flow.
All channel types can also access the PFL, and AFL (left and right) solo buses.
All primary outputs Balanced XLR connectors,
50R source
Master channels
Aux, group, matrix,
monitor and local
(monitor) buses
Talk mic in talk mic
section of outputs (control
surface)
All secondary outputs
(direct outs)
Balanced Jack connectors,
50R source
Mono channels
Headphone outputs Jack connectors, 10R
source (nominal +10dB)
local monitor section of
outputs (control surface)
Playback left and right
inputs and outputs
Unbalanced phono
connectors, 600R source
(nominal -10dB)
Rear panel
FireWire connections FireWire (FW 4000 6-pin)
connector to IEEE1394
Rear panel
Power connections IEC mains inlet
4-pin XLR lamp power
outlets
Rear panel
Under top edge of rear of
console
Channels or inputs Route to
8, 16 or 24 mono mic/line channels 2 monitor, 4 aux, 4 group and 3 master
buses, and FireWire (8, 16 or 24
channels)
4 stereo mic channels 2 monitor, 4 aux, 4 group and 3 master
buses, and FireWire (8 channels)
4 stereo line inputs The same numbered stereo channel and
then onwards (as above) or the stereo
master bus
2 stereo return channels 2 monitor, group 1-2 (return 1) and
group 3-4 (return 2), and the stereo
master buses
4 group channels 3 master and 2 matrix buses
3 master channels 2 matrix buses
4 aux channels N/A
2 monitor channels N/A
2 matrix channels N/A
Connection(s) Description Notes