Specifications

20 Chapter 3: Using The VeniceF With FireWire
VeniceF
Operator Manual
Step B — Connecting the VeniceF to your PC
Important:
The VeniceF must be switched off before the FireWire cable is connected to it.
When you use your PC with the VeniceF for the first time after installing the FireWire
device driver, you will need to install the VeniceF device software. This is so that your
PC will recognise the VeniceF whenever they are connected together.
>> To connect the PC to the console
Do not attempt the following procedure until you have completed Step A
(see “Step A — Installing the device driver on your PC” on page 17).
1 Switch off the VeniceF.
2 Connect the VeniceF to the PC using the appropriate FireWire cable, while
observing the following precautions. Plug the 6-pin connector into the FireWire
socket of the FireWire section on the rear of the console. Connect the other end
of the cable into the PC.
Figure 3: Some typical FireWire connectors
Make sure you use the correct FireWire cable connector with your PC.
When plugging the FireWire connector into your PC, make sure the
connector is the correct way up and take great care not to exert too much
force.
3 In the Found New Hardware Wizard
window, select the No, not this time
option and then click Next.
6-pin (VeniceF)
9-pin
4-pin