Specifications

Master outputs (mono and stereo) 67

VeniceF

Operator Manual

FireWire output is available for the left and right master channels by the overriding the

relevant dual stereo input channel. There is no FireWire output for the mono channel.

For more information, see “FireWire” on page 58.

The controls shown in this section are directly responsible for the main outputs from the

console.

Master outputs sections on the control surface

Item Description

1 MUTE switch and red LED This MUTE switch (in the all stereo line to

masters section) mutes the stereo returns and any stereo line inputs of the

stereo modules that are routed directly to masters, that is, when the

channel/masters switch in the dual stereo input channel is set to masters

(see “Stereo line inputs” on page 47). The LED illuminates to show that the

switch is on.

2 stereo to mono switch When this switch is on, a sum of the stereo left

and right signals are routed to the mono signal bus (post-mute and post-

insert points).

3 bal control knob Provides fine adjustment of the left and right power

levels, and can be used during set up to check the left and right channels

separately (by panning fully left or right).

4 MUTE switches and red LEDs These MUTE switches mute the stereo/

mono signals pre-fader. Each red LED illuminates when its mute is on.

5 SOLO switches and yellow LEDs The SOLO switches route the stereo/

mono signal to the PFL mono and AFL stereo buses. The LED for each solo

switch illuminates when its solo is on. Master solo will be overridden by any

other channel/mix solos.

6 Faders These master output faders adjust the output levels, which are

continuously variable from

4 (infinity/off) to +10dB.