Technical data

INSTALLATION INSTRUCTIONS

INSTRUCTIONS FOR INSTALLATION

This appliance shall be installed only by authorised personnel and in accordance with the

manufacturer's installation instructions, local gas fitting regulations, municipal building codes,

water supply regulations, electrical wiring regulations, AS 5601/AG 601 - Gas Installations and

any other statutory regulations.

Gas safety Regulations (Installation & Use)

Installation Instructions

POSITIONING THE APPLIANCE

Combustible Surfaces

- Any adjoining wall surface situated within 200mm from the edge of any

hob burner must be a suitable non-combustible material for a height of 150mm for the entire

length of the hob. Any combustible construction above the hotplate must be at least 700mm

above the top surface of the bench and no construction shall be within 450mm above the top of

the burner. Allow a 10mm minimum clearance below the hotplate.

Ventilation

- Ventilation must be in accordance with AS5601/AG 601 - Gas Installations. In

general, the appliance should have adequate ventilation for complete combustion of gas, proper

flueing and to maintain temperature of immediate surroundings within safe limits.

PRE-COMMISSIONING THE APPLIANCE

When unpacked, check that the following parts are included with the appliance:-

x Instruction and Installation Book

x Pan Supports

x Burner Assemblies

x Adhesive sealing strip and fixing clamps & screws

x ½ BSP Elbow & Seal

x LPG conversion kit comprising an LPG jet for each burner and a self-adhesive label for

amending Gas Category on the appliance Rating Label.