User manual

3.2 ANNUAL MAINTENANCE (FALL)
Repeat steps 1 to 6 from the previous Section and continue with the following steps:
3.2.1 Clean the recovery module.
A- Polypropylene core (Solo)
• Remove the recovery core.
• Let it soak in a mixture of cold or
lukewarm water and mild soap
(dishwashing liquid).
• Rinse thoroughly.
• Shake the core to remove excess
water and let it dry.
B-
Thermal wheel (Duo)
• Disconnect the thermal wheel
wires.
• Remove the thermal wheel.
• Remove dust using a vacuum
cleaner with a soft brush attachment.
VD0142
VD0143
SOLO
DUO
CAUTION
Handle the recovery module with care.
CAUTION
This type of recovery module cannot be washed with water.
WARNING
Dangerous voltage may be present. During maintenance and repairs, the unit must
always be turned off, then unplugged.
We take great care to minimize sharp edges; however, please proceed with caution
when handling all components.
0
!
18
3.1 EVERY THREE MONTHS (CONT’D)
5. Clean the condensation tray with a damp cloth.
6. Check the exterior air intake hood :
• Make sure there are no leaves, twigs, ice or snow
that could be drawn into the vent.
• Clean if necessary.
7. Reassemble the components:
• Filters
• Door (The door is secured when you hear a click.)
8. Reconnect the power supply.
VD0035
CAUTION
Even a partial blocking of this air vent could cause the unit to malfunction.