User Manual

ManualsBrandsVenom Group ManualsHobbyAtomik Red Sensored 120A ESC/550 4.5T BL, 4400Kv

2 Cell LiPO

Motor Diameter:

Motor Length:

Weight:

Shaft Diameter:

Rotor Diameter:

Wind Type:

36 mm

65.80 mm

8.4oz (240g)

5.0 mm

12.50 mm

Star (Y) wind

GEARING AND TIMING

Timing can be adjusted by loosening the three screws and

rotating the aluminum end cap. Rotating the end cap counter-

clockwise adds timing which increases the motor’s RPM. Be

aware that by adding timing, motor temperatures will increase

and battery duration will decrease. Those with limited motor

tuning experience should leave the timing at the factory setting.

INSTALLATION AND MAINTENANCE

•Solder the three leads from your Electronic Speed Control

(ESC) noting the A, B, and C connections. Do NOT allow

solder to bridge the gap between each connection.

•To clean your motor, lightly brush dirt away on a regular

basis paying particularly close attention to the area around

the ball bearing. Occasionally add a small drop of bearing oil.

DO NOT spray cleaners or solvents into the motor.

PRECAUTIONS & WARNINGS

•Avoid over gearing by monitoring motor temperature.

Operating temperatures should NOT exceed 80C (175F)

•Be sure to use the proper size motor mounting screws

•Do NOT over-tighten the motor mounting screws

Sensor Wire

Orange

Blue

4.5T

WIRING DIAGRAM

Yellow

P/N

13018 90 0.0067 No4.5

Winds

4400

K/v Max Current Resistance ROAR

Approved

Specifications:

Summary of content (2 pages)

PAGE 1
WIRING DIAGRAM Yellow Orange Blue A Specifications: 2 Cell LiPO Motor Diameter: Motor Length: Weight: Shaft Diameter: Rotor Diameter: Wind Type: P/N Winds K/v 13018 4.5 4400 Max Current Resistance 90 0.0067 36 mm 65.80 mm 8.4oz (240g) 5.0 mm 12.50 mm Star (Y) wind ROAR® Approved No GEARING AND TIMING Timing can be adjusted by loosening the three screws and rotating the aluminum end cap. Rotating the end cap counterclockwise adds timing which increases the motor’s RPM.
PAGE 2
General Warranty Policies Atomik® warrants this product to be free of material and workmanship defects when new. Atomik® will at its sole discretion repair or replace defective components free of charge within 90 days from date of purchase or within 30 days for all electronic components. This warranty does not cover wear and tear, crash damage, modifications, failure to perform routine maintenance, or any damages arising as a result of improper use.