Installation Manual

ManualsBrandsVenstar ManualsTelecom Equipment1DX Communication Module

Venstar – 1DX

1DX – Manual

FCC ID of this product is as follows.

FCC ID: MUH-DAlKlN1P2

IC ID: 12547A-DAIKIN1P2

For OEM integration only — device cannot be sold to general public. Therefore we

will ask OEM to include the following statements required by FCC on the product

and in the installation manual notice.

Contents

1. Voltage

2. Antenna

3. Notice

Summary of content (4 pages)

PAGE 1
DX – Manual FCC ID of this product is as follows. FCC ID: MUH-DAlKlN1P2 IC ID: 12547A-DAIKIN1P2 For OEM integration only — device cannot be sold to general public. Therefore we will ask OEM to include the following statements required by FCC on the product and in the installation manual notice. Contents 1. Voltage 2. Antenna 3.
PAGE 2
1. Supply Voltage Specification Temperature Range Specification Voltage Min. -40 VBAT 3.0 VDDIO 1.71 Typ. +25 3.6 1.8or3.3 Max. +85 4.8 3.63 Unit deg.C V V 2. Antenna Please perform the antenna design that followed the specifications of the antenna. The concrete contents of a check are the following three points. 1) It is the same type as the antenna type of antenna specifications. Confirm the same size as the Gerber file. 2) An antenna gain is lower than a gain given in antenna specifications.
PAGE 3
. Notice For OEM integration only — device cannot be sold to general public. Therefore we will ask OEM to include the following statements required by FCC/IC on the product and in the Installation manual Notice. Please describe the following warning on the final product which contains this module.
PAGE 4
This device contains licence-exempt transmitter(s)/receiver(s) that comply with Innovation, Science and Economic Development Canada’s licence-exempt RSS(s). Operation is subject to the following two conditions: 1. This device may not cause interference. 2. This device must accept any interference, including interference that may cause undesired operation of the device.