User's Manual

9
Step 5 - RemoveCurrentBackplate
Unscrewthecurrentbackplateand
removeitfromthewall.Becareful
not to let the wires fall into the wall.
Step 6 - MountNewBase
1) Gentlyseparatethedisplayfromthebasebypullingfirst
from one side, then the other until the two pieces unsnap.
A small screwdriver may be used, very carefully, to start
seperating the two pieces.
TIP: If needed, wrap the wires
around a pencil or pen to keep
them from falling inside the wall.
2) Positionthebaseagainstyour
wall, and determine if wall
anchors from current thermostat
align with screw locations of
new base.
3) Ifbasedoesnotalignwith
existinganchorholes,marknew
screw locations with a pencil.
Drywall:Drill3/16"holefor
the anchor
Plaster:Drill7/32”holefor
the anchor
4) Pullwiresthroughopeningin
base and secure to the wall
using provided screws.
TIP:Usealeveltoensure
thermostat is properly aligned
before marking screw locations.