User Guide

Programming Occupied & Unoccupied Periods
Press
If Yes is selected:
Selecting Yes, then pressing MODE will
copy the previous day’s program and then
will ask the same copy question again. If
yes is selected each time, this routine will
repeat until Saturday is copied to Sunday.
After Saturday is copied to Sunday, the
copy command is unavailable.
Off
On
Yes
No
MODE
Press
Press
If No is selected:
MODE
MODE
Occupied
Tu
1
ON
We
Select Yes to copy the
previous day’s program
to the day displayed.
on this day (On), or not to
run on this day (Off).
Select Occupied 1 to run
If No is selected, as in previous steps, flashing prompts will
appear to input start and stop times for Occupied 1. If more
than one occupied period was selected in the first programming
step (page 9), then the cool and heat setpoints, and start and
stop times for each additional occupied period will be prompted.
MODE
After programming for all seven days is complete, press
the MODE and UP buttons at the same time for two seconds
to leave the Setup screens. If no buttons are pressed, the
display will leave the setup screens after 30 seconds.
Page 12