User Guide

Programming Occupied & Unoccupied Periods
PROGRAMMING TIPS
Page 13
If only the Occupied 1 period is selected in the first programming
step (page 9), Occupied 2 & 3 programming steps are skipped.
Furthermore, if Occupied 2 is selected, Occupied 3 programming
steps are skipped.
Heat & Cool setpoints for Occupied 1 are the same for every day of
the week. If desired, Heat & Cool setpoints for Occupied 2 & 3 can
be adjusted differently for each day of the week.
If the start time is set later in the day than the stop time, the
program will run from the start time to midnight and from midnight
to the stop time on the same day. For example: 9pm start, 8am
stop, on Monday. In this example the program will run from 12am
Monday to 8am Monday and again from 9pm Monday to 12am
Tuesday.
Unoccupied Operation: The unoccupied settings take effect at
all times when: (1) the program is on and (2) the current time is
outside a preset occupied period. For this reason start and stop
times are not necessary for unoccupied time periods.
If the same start and stop times are programmed for an occupied
period, then it will run 24 hours.
If one occupied period starts and stops within another occupied
period the lower occupied # has priority. For example: If Occupied
3 is programmed to be on for 24 hours, and Occupied 2 is program-
med to run that day, then the Occupied 2 setting will take over for
Occupied 3 between Occupied 2 start and stop times.