Quick Start Guide
9
Step 5 - RemoveCurrentBackplate
Unscrewthecurrentbackplateand
removeitfromthewall.Becareful
not to let the wires fall into the wall.
Step 6 - MountNewBase
1) Gentlyseparatethedisplayfromthebasebypullingfirstfrom
the bottom and then the top until the two pieces unsnap.
TIP: If needed, wrap the wires
around a pencil or pen to keep
them from falling inside the wall.
REMOVE THE THERMOSTAT BACKPLATE:
UsingtheFingerPullAreas,pullthefront
housing away from the backplate.
W3/AUX
W2
W1/O/B
Y2
Y1
SENSOR
Backplate
PULL OUT WITH THUMBS IN THESE AREAS.
2) Positionthebaseagainstyour
wall, and determine if wall anchors
from current thermostat align with
screw locations of new base.
3) Ifbasedoesnotalignwithexisting
anchor holes, mark new screw
locations with a pencil.
Drywall:Drill3/16"holefortheanchor
Plaster:Drill7/32”holefortheanchor
4) Pullwiresthroughopeninginbase
and secure to the wall using
provided screws.
TIP:Usealeveltoensure
thermostat is properly aligned
before marking screw locations.