Quick Start Guide

Step 7 - Connect Wires

1) Matchyourpreviouswireconﬁguration

tothenewbase.Onebyone,connect

each wire by inserting the metal end into

the corresponding slot and tightening

the screw.

W3/AUX

W1/O/B

SENSOR

TIP: Useplierstostraightenwirebeforeinserting

intonewbase.Besuretocutanyexcesswiresothat

theinsulationextendstotheterminalblock.When

the wire is installed properly to the terminal block,

thereshouldbenocopperexposed.

WiFi Network

& Password

Screw Driver

Pencil

LevelPliers

Hammer or Drill

(3/16" or 7/ 32" drill bits)

Thermostat

Base

Drywall Anchors

and Screws

This Quick Start

Manual

W3/AUX

W1/O/B

SENSOR