Quick Start Guide
6
MAKING 4 WIRES WORK when 5 are required
(without the optional Add-A-Wire accessory)
• If you have an all-electric heat system with air conditioning, this
method is not an option. You must either pull new wire or use the
optional Add-A-Wire accessory (ACC-0410).
• If you have a single stage fossil fuel heater with air conditioning,
and you would like install the Venstar ColorTouch using only 4 wires,
follow the directions below. You will need a screwdriver along with a
3” or 4” long piece of thermostat wire to use as a jumper.
1. Makesurethepowerisoasstep1onpage4instructsyou.
2. Followstep4onpage9“LabelandDisconnectWires”atthe
thermostat.Pleasenotethecolorandthecorrespondingwire
designatorwitheachcolor.AnexampleistheRwireisredandthe
Wwireiswhiteandsoon.Youwillneedthisforthenextstepat
theHVACequipment.
3. Attheequipmentendofthethermostatwires,locatethe
terminals that the wires are attached to.
A. Removethe“Gwire”fromtheterminalmarkedG.
B. Placethe“Gwire”onterminalC.
C. PlaceoneendofthejumperonterminalG.
D. PlacetheotherendofthejumperonterminalY.
Pleasenotethattherewillbemorethan1wireonterminalY.
4. Connect the wires to the terminals on the ColorTouch backplate
takingcaretomakesurethateachwirefromtheHVACequipment
is connected to the same terminal designation on the ColorTouch
backplate.Forexample:the“Cwire”fromtheHVACequipment
shouldbeconnectedtothe“C”terminalofthethermostat.The
“R”wireontheequipmentterminalshouldbeconnectedtothe
“R”terminalontheColorTouchbackplate,andsoon.