User Guide

Table Of Contents

PAGE 1
IMPORTANT: READ ALL OF THESE INSTRUCTIONS BEFORE INSTALLING THE BIT-515. SAFETY CONSIDERATIONS Read and follow the manufacturer instructions carefully. All wiring must conform to local and national electrical codes. Improper wiring or installation may damage the sensor. Recognize safety Information. This Is the safety alert symbol A. When the safety alert symbol Is present on equipment or in the instruction manual, be alert to the potential for personal injury.
PAGE 2
STARVE @ NE-515 Wiring @ At the UCP board: Remove the P7 connection cable from the J7 terminal block. @ At the BIT-515 board: Install the P7 connection cable on the J1 terminal block. © Connect the J2 terminal block of the BIT-515 to the J7 terminal block of the UCP, using the included TIBET connection cable. © Thermostat Wiring Connect your conventional or heat pump w2 thermostat to the Tran VAC unit ya terminal block as shown.