installation instructions

ManualsBrandsVent-A-Hood ManualsWall-Mounted Range HoodsVent-A-Hood® 36" Duct Free Wall Mounted Range Hood-Black-CWEAH6-K36 BL

Page 1L155 0418A

CUS

Read and Save These Instructions

All Hoods Must Be Installed By A Qualied Installer

INSTALLATION INSTRUCTIONS

WALL MOUNT HOODS

WITH AIR RECOVERY SYSTEM

Read All Instructions Thoroughly Before Beginning Installation

WARNING - TO REDUCE THE RISK OF FIRE, ELECTRIC SHOCK,

OR INJURY TO PERSONS, OBSERVE THE FOLLOWING:

A. Installation work and electrical wiring must be done by qualied

person(s) in accordance with all applicable codes and standards,

including re-rated construction. Switch power o󰀨 at service panel

and lock the service disconnecting means to prevent power from

being switched on accidentally during installation.

B. When cutting or drilling into wall or ceiling, do not damage electrical

wiring and other hidden utilities.

C. Su󰀩cient air is needed for proper combustion and exhausting of

gases through the ue (chimney) of fuel burning equipment to

prevent back drafting. Follow the heating equipment manufacturer’s

guideline and safety standards such as those published by the

National Fire Protection Association (NFPA), and the American

Society for Heating, Refrigeration and Air Conditioning Engineers

(ASHRAE), and local code authorities.

Summary of content (4 pages)

PAGE 1
Read and Save These Instructions All Hoods Must Be Installed By A Qualified Installer INSTALLATION INSTRUCTIONS WALL MOUNT HOODS WITH AIR RECOVERY SYSTEM Read All Instructions Thoroughly Before Beginning Installation WARNING - TO REDUCE THE RISK OF FIRE, ELECTRIC SHOCK, OR INJURY TO PERSONS, OBSERVE THE FOLLOWING: A. Installation work and electrical wiring must be done by qualified person(s) in accordance with all applicable codes and standards, including fire-rated construction.
PAGE 2
Installation Details 1) Read all instructions thoroughly before beginning installation. Note: These instructions apply to standard hoods only. Custom hoods may require additional specification consideration. 2) When installing a wall mount Air Recovery System (ARS), it is recommended that the bottom edge of the hood be located no more than 24” above the cooking surface for optimum performance. ARS Filter & Duct Cover CWEAH6-K Shown with Air Recovery System (sold separately).
PAGE 3
Installation Details Continued 4) Remove the duct cover from its packaging. Remove the duct cover front panel. The panel is held in place with four snaps at the corners and at least one snap on the left and right. Begin by pulling the panel away at one corner using the suction cup provided. Work around the duct cover disengaging one snap at a time until all the snaps are loose. Beware of sharp corners and edges. Use caution to prevent bending, scratching or dropping the cover.
PAGE 4
Installation Details Continued 13) Remove the filter assembly from it's packaging. With the handles towards the front of the range hood, lift the odor absorbing canister. Hold the canister so that the canister bottom is just above the the bottom of the duct cover opening and slide the canister into the duct cover. 14) Move the canister all the way to the back and then lower the canister over the blower discharge.