installation instructions

Page 4L155 0418A
ODOR
ABSORBING
CANISTER
BLOWER
DISCHARGE
ODOR
ABSORBING
CANISTER
BLOWER
DISCHARGE
SMOKE
TRAPPING
FILTER
ODOR
ABSORBING
CANISTER
BLOWER
DISCHARGE
Installation Details Continued
13) Remove the lter assembly from it's packaging. With the
handles towards the front of the range hood, lift the odor
absorbing canister. Hold the canister so that the canister
bottom is just above the the bottom of the duct cover opening
and slide the canister into the duct cover.
14) Move the canister all the way to the back and then lower the
canister over the blower discharge. Shift the canister front to
back and left to right to make sure that the blower discharge
and canister have fully engaged.
15) With the gasket side facing down, nest the smoke trapping
lter element into the pocket that forms the top of the odor
absorbing canister. The lter may have a rectangular base
so rotate as necessary. Replace the duct cover front panel by
aligning the snaps and pressing each snap into position.
16) Refer to the Owner Maintenance Guide for Models Equipped with K250 Blower for proper hood operation. Test all
blower and light functions to ensure they are operating properly.