installation instructions
Page 2L164 0520A
Electrical
Installation Details
1) Read all instructions thoroughly before beginning installation. Note: These instructions apply to standard hoods only.
Custom hoods may require additional specication consideration.
NOTE: For optimum performance, the Air Recovery System (ARS) lter assembly will require routine maintenance. In
order to accommodate this requirement, the enclosure must be constructed with at least one removable outside panel
that is large enough to remove the lter assembly or assemblies.
NOTE: This is a recirculating product which means that there must be openings for the reclaimed air to re-enter the
room upon exiting the lter assembly. A minimum of 25 sq. in. of exhaust opening space per blower/lter assembly,
located above the lter assembly outlet (top), is required for proper air recirculation.
2) When installing an ARS under cabinet range hood, it is recommended that the bottom edge of the hood be located
21" – 24” above the cooking surface for optimum performance.
3) Inspect the underside of the cabinet for a ush mounting surface. If the underside of the cabinet is recessed, install
wood strips to provide a ush surface for the hood mounting screws to engage.
4) Cut openings in the base of the cabinet for the lter area footprint and electrical connection. Consult the connection
diagram (below) for further details on cutout placement.
5) Remove the hood from its packaging and place on the oor or countertop in front of the cabinet where it will hang.