VENTA AIRWASHER KUUBLET (LW15), KUUBE (LW25), KUUBEL (LW45) USER MANUAL READ AND SAVE THESE IMPORTANT INSTRUCTIONS QUESTIONS? SERVICE HOTLINE 888-333-8218 AIR-CRAFTING SINCE 1981 MADE IN GERMANY PREMIUM QUALITY
VENTA AIRWASHER User Manual FOR MODELS KUUBLET (LW15), KUUBE (LW25), KUUBEL (LW45) CONTENTS: Important Safeguards--------------------------------------------------------------- 3 Quick Start Guide ------------------------------------------------------------------- 4 Letter to Our Customers ----------------------------------------------------------- 9 Parts List---------------------------------------------------------------------------- 10 Maintenance and Cleaning ---------------------------------------
IMPORTANT SAFEGUARDS WARNING! It is important that you read, fully understand, and observe the following safety precautions and warning. Read these instructions periodically. Careless or improper use of your Venta Airwasher may cause serious or even fatal injury. Keep this User Manual with your Airwasher. Be sure anyone using your Airwasher understands the information contained in this manual. • Children should not operate the Airwasher.
Easy Setup Guide Welcome to the Venta Family! Setting up your Airwasher is much simpler than you would expect. Just follow these 7 steps and your Airwasher will be up-and-running in less than 10 minutes! 1. Unpacking First things first, remove bottle(s) of Water Treatment Additive from the corner of your packaging. Keep these handy as you’ll need them in a bit. Unpack your Airwasher setting the Styrofoam aside.
Lift the motor out of the housing, remove the power cable, and set it aside for a moment. On the inside of one of the panels is a sticker with the serial number on it. Write this number down as you’ll need it later! 3. Check it Out (Part 1) Check both the upper housing and the motor for any cracks or damages. If both are fine, place the motor back inside its housing, making sure to plug it back in as you do so. Close the upper housing, starting with the vented panels, and clip the tabs.
4. Check it Out (Part 2) Remove the disc stack(s) from the lower housing and set them aside. Remove the protective cardboard from the upper and lower housings. Check the lower housing and the disc stack(s) for any cracks or damages. If everything is fine, put the disc stack(s) back in the lower housing. Undo the tie holding the power cord and place the upper housing on the lower housing, guiding the power cord out through the slot provided. Please contact Venta Air Technologies Inc.
Remove the upper housing from the lower housing and set it aside for a moment. Take the lower housing over to your sink/bathtub/water source and fill it with regular tap water up to the water line. Remember the bottle(s) of Water Treatment Additive? Go grab those and pour them into the water in the lower housing. Once it’s filled, carry it back over to the upper housing. Place the upper housing back onto the lower housing. 6.
7. Activate your Warranty Remember that serial number you wrote down earlier? Use that serial number to complete the registration card here in the manual to register your unit and activate your 10-year warranty! Congratulations! Your Airwasher is now fully functioning! HELPFUL HINTS • Dishwashers: The Venta Airwasher’s lower housing, disc stack(s), and upper housing (first removing the motor assembly from the upper housing) can go into a dishwasher on the cool or rinse cycle.
Dear Customer, Thank you for choosing the Venta Airwasher, the best 2-in-1 humidifier and purifier on the market. With its humidification and purification system, Venta represents a unique and revolutionary technology. The only filter needed is fresh water. With proper maintenance, the Venta Airwasher will consistently perform at a high level, providing perfect indoor air. WHY IS THE VENTA 2-IN-1 SYSTEM A UNIQUE AND REVOLUTIONARY TECHNOLOGY? 1.
Main Components Disc Stack Handle Disc Stack Lower Housing Upper Housing Water Level Sensor Strip Gear Teeth Gear Support Arm Gear Gear Support Arm Rubber Coupling Mounting Ring Fan Blade Power Button Power Level Continuous Lighting: On No lighting: Off Flashing: Fault (See Eliminating Faults) Power Adjustment Button Low Water Indicator
Maintenance and Cleaning DAILY Fill with fresh tap water. Make sure you don’t dump the remaining water in the unit when you fill it, as this water contains the Water Treatment Additive. EVERY 10-14 DAYS Rinse lower housing and disc stack(s) with warm water. Wipe lower housing and fan blade with soft cloth. Recharge with recommended dose of Venta Water Treatment Additive and fresh tap water. TWICE A YEAR Use the Venta Cleaner periodically to thoroughly clean the Venta Airwasher.
Venta Water Treatment Additive APPLICATIONS Venta Water Treatment Additive (WTA) is designed to maintain hygienic conditions in the lower housing and to keep the evaporation process functioning at the highest level. The use of WTA is recommended for the best performance and efficiency of your Venta Airwasher. Proper usage will prevent the formation of hard calcium deposits. Simply rinse and wipe out any sediment when changing the water.
Venta Cleaner Use every six months or more frequently if needed. 1. For thorough cleaning, fill lower housing with water before adding the entire contents of the bottle. Run the appliance on the lowest setting for approximately two hours. 2. Empty lower housing and rinse disc stack(s) and lower housing with warm water. 3. Fill lower housing with water and add one dose of WTA.
Additional Information Technical data Kuublet (LW15) Kuube (LW25) Kuubel (LW45) For rooms up to 200 sq.ft. 400 sq.ft. 800 sq.ft. Mains voltage 100-240 V / 50-60 Hz 100-240 V / 50-60 Hz 100-240 V / 50-60 Hz Disk surface 15.3 sq.ft. 22.5 sq.ft. 45 sq.ft. Speeds 2 3 3 Sound level 22/32 dBA 24 / 34 / 44 dBA 24 / 35 / 45 dBA Dimensions 10.2×11×12.2 in 11.8×11.8×13 in 17.7×11.8×13 in Weight (empty) ~7 lb. ~8.5 lb. ~13 lb.
Troubleshooting Problem Possible causes What to do Appliance does not function 1. Power supply not connected. 1. Connect switching power supply to main socket, switch on appliance. 2. Cable connector not plugged in and latched into drive unit. 2. Plug main cable connector into drive unit until it latches.
Frequently Asked Questions HOW DOES THE VENTA AIRWASHER HUMIDIFY? The Venta Airwasher operates by the process of cold evaporation, so you will not see any residue, vapors, or mists. The disc stack(s) rotates in the water creating a surface area of over 45 sq. ft. (Kuubel (LW45)). When dry air meets the surface area of the disc stack(s), the water evaporates and is sent out into the room. By using the cold evaporation process, any excess humidity can be virtually ruled out.
IS IT NECESSARY TO USE THE VENTA WATER TREATMENT ADDITIVE? The WTA helps prevent mineral deposits from becoming too hard and difficult to remove so that any sediment can be rinsed out. In addition, the WTA helps improve the efficiency of the Venta Airwasher by allowing the water to sheet on the disc stack(s) instead of “beading” up, allowing maximum use of every square inch of the disc stack(s). The WTA also helps prevent odors and improves the performance of the Venta Airwasher.
Servicing Your Airwasher CLEANING THE GEAR DO NOT submerge the gear in water. To clean any buildup of calcium or lime from the gear “teeth,” brush with a soft bristled brush. The gear teeth should be pointed toward the floor while brushing, otherwise deposits will fall into the gear and cause it to malfunction. REMOVAL OF THE GEAR AND COUPLING 1. Switch the unit off. that it is laying on its side. 2. Unplug the power cord from the 6. Gently pull one of the two motor outlet.
Fig 7. Remove the locking ring ... prying it up using a small screwdriver ... REPLACING THE GEAR AND COUPLING A. Place the rubber coupling into the locking ring so the rubber feet from the coupling hang below the ring. When placing the coupling and ring on the center shaft of the fan, the rubber feet should line up with the notch marks on the fan. Snap the ring and coupling into place. B. With the gear laying on its side, place it between the motor housing arms that suspend it above the fan. C.
Fig D. ... and push it up into the gear until it fits tight ... models with a small white pin, first insert the pin through the rubber coupling and then push both up into the gear until it fits. Additional Service Options In case you prefer Venta to handle your concern, warranty repair, or if you wish to utilize the Ultrasonic Cleaning service for your Venta Airwasher, please call our customer service department toll-free at 888-333-8218 to obtain a Return Merchandise Authorization (RMA) number.
Ten-Year Limited Warranty CALL VENTA CUSTOMER SERVICE TO TROUBLESHOOT ANY ISSUES, BEFORE ATTEMPTING TO RETURN PRODUCT TO RETAILER. If you have any questions regarding this warranty, please call 888-333-8218 or write to: Venta Air Technologies Inc. US Headquarters 300 N Elizabeth St. Suite 220B Chicago, IL 60607 For product registration please return the enclosed Warranty Card.
CUSTOMER SERVICE: AIR-CRAFTING SINCE 1981 Art.-No. 78500-36, © 2018/03_V01 Venta Air Technologies Inc., US Headquarters 300 N Elizabeth St. Suite 220B Chicago, IL 60607 Toll Free: 1-888-333-8218 www.venta-usa.com e-mail: info@venta-usa.
