User manual

14
EVERY 10-14 DAYS
Illustration 4:Switchoffapplianceandpulloutswitchingpowersupply.Pouroutsoiledwater.
Brushoffprecipitateddepositsinthelowerhousingandushout.Flushdiskstackwithwater.Fill
lowerhousingwithwateragain.RellwithVentahygieneagent.Fordosing,seescaleonbackof
bottle.
All residues in the lower housing and on the disk stack (white, green-yellowish or brownish precipi-
tation) do NOT impair the function of the Venta Airwasher. As a result of the addition of the hygiene
agent, trouble-free hygienic operation is guaranteed.
Dosage for models
LW 15 = Dosage for LW 14, LW 25 = Dosage for LW 24, LW 45 = Dosage for LW 44
See back of the bottle.
EVERY SIX MONTHS
Werecommendasix-monthlygeneralcleaningwiththeVentaCleaner.Accordingtothedegree
ofpollutionoftheairwasher,odorscanpossiblyariseduringcleaning.Pleaseprovideforfreshair
ventilationinthesecases.TheVentaCleanerwasespeciallydesignedtobecompatiblewithVenta
plastics,withoutattackingthem.Pleaseconsiderdirectionsforuseonbottle.
GENERAL CLEANING
Illustration 5:Switchofftheapplianceandpulloutswitchingpowersupply.Fortheopeningof
theupperhousing,pressonthelockinglatch(seearrows).
Illustration 6: It is absolutely necessary to consider the sequence during the opening of
the top cover: First pivot aside the two sides
1
+
2
(with light pressure) and after that pivot
out the two ribbed wings
3
+
4
.
Illustration 7:Removemainscableconnectorfromdriveunit
1
.Liftoutdriveunit
2
.Remove
mainscablefromholder
3
andpulloutthroughopeningintheupperhousing
4
.
• Do not dismantle unit and switching power supply, do not immerse in water and do not bring
into contact with liquid!
• Clean drive unit, fan blade and gearing with dry cloth!
• Dismantled upper housing can be cleaned under owing water.
• Dismantled upper housing must be completely dry before assembly!!!
Illustration 8:Placedriveunitintotheupperhousingincorrectalignment
1
.Pullmainscable
connectorupfromunderneaththroughtheopeningoftheupperhousing
2
andplugintodrive
unituntillatched
3
.Clipmainscableintoholder
4
.
Illustration 9: For the closing of the upper housing it is absolutely necessary to follow
the sequence: Place the external ends of the latches in the up position! First pivot up the two
ribbed wings
1
+
2
and press on the external ends of the latches (see rings). After that pivot
up the two side parts
3
+
4
and engage in latch.