Operating instructions
29
Window Retting
1. To ret the window, place it in its bottom railing and
push its top against the rebox.
2. While you hold it, pull the side levers back into the
window brackets on each side.
3. Pull out the top of the window and release it to
insure the springs return it.
4. Apply light hand pressure against the window frame
sides to bed-in the window seal.
Section
Views
Initial Remote Control Set-up
The receiver and the handset of the remote control system
must be initially synchronized before the rst use.
1. Insert batteries in the remote control receiver and
handset. The receiver is located left of the control valve
under the burner module.
2. With a sharp object, press and hold the receiver’s reset
button until you hear two (2) acoustic signals. After the
second, longer acoustic signal, release the reset button.
3. Within the subsequent 20 seconds, press the (small
ame) button on the remote handset until you hear an
additional long signal conrming the sychronization is set.
This is a one time setting only and is not required when
changing the batteries in the remote receiver. The remote
control system is now ready to use.