Owner`s manual

39
Install Liners
The following guidelines apply for all brick liners.
1. Inside the fi rebox, on the top of each side, release
the screw of the side brick anchors (one per side).
2. Place the rear panel against the back of the fi rebox,
behind the retainer at bottom.
3. Hold the left hand side panel at an angle and insert
it totally inside the fi rebox, behind the top outer
edge of the fi rebox. This will greatly facilitate the
installation. Slide the bottom fi rst and then the top
against the side of the fi rebox. Rotate the side brick
anchor to hold the panel in place.
4. Place the top panel over the top edge of the rear
and side panels. Leave the panel to balance there
until right hand side panel is installed.
5. Hold the right hand side panel at an angle and
insert it totally inside the fi rebox, behind the
top outer edge of the fi rebox. This will greatly
facilitate the installation. Slide the bottom fi rst
and then the top against the side of the fi rebox.
You may have to lift the top panel slightly to avoid
scratching it. Rotate the side brick anchor to hold
the panel in place.
6. Make any adjustment by moving the rear top panel
slightly.
7. Tighten the side brick anchors on each side of the
fi rebox.
Top of panel
behind the top
outer edge of
the fi rebox
Top of panel
behind the top
outer edge of
the fi rebox
Installation
QUALIFIED
INSTALLER