FRIGATE ERV Installation Guide

www.vents-us.com
MIU_35_50_ERV+HRV-01
Vents-US
400 Murray Road, Cincinnati, OH 45217, USA
Tel: [phone], Fax: [phone]
E-mail: [e-mail]
HEAT (ENERGY) RECOVERY VENTILATOR
Frigate ERV 80 Frigate ERV 100
Frigate ERV 120 Frigate ERV 150
Frigate ERV 80 R Frigate ERV 100 R
Frigate ERV 120 R Frigate ERV 150 R
Frigate ERV 80 EC Frigate ERV 100 EC
Frigate ERV 120 EC Frigate ERV 150 EC
Frigate ERV 80 R EC Frigate ERV 100 R EC
Frigate ERV 120 R EC Frigate ERV 150 R EC
INSTALLATION GUIDE
INSTALLATION
Tools required
Pencil Drill Screwdriver Dowel Screws
MOUNTING
While mounting the unit provide enough access for maintenance or repair work.
The minimum recommended clearances between the unit and the adjoining walls are given in the gure below.
When selecting a mounting location of the unit provide free opening of the service panel.
To attain the best performance of the unit and to minimise turbulence-induced air pressure losses connect the straight air duct section to the spigots on both sides of the unit
while mounting.
Minimum straight air duct length:
• equal to 1 air duct diameter on intake side
• equal to 3 air duct diameters on outlet side
Mount the unit to ceiling by means of the belts that are rigidly fixed to horizontal plane or with threaded rods fixed inside the dowels attached to the ceiling. The unit may
be mounted to the wall with a suspension bracket that is fixed to the unit with three screws and dowels.
min 2 inch
min 10 inch
min A
Fig. 3. Ceiling unit mounting example
MODEL SIZE, А
FRIGATE HRV/ERV 80 (R) (EC) 21”
FRIGATE HRV/ERV 100/150 (R) (EC) 25”
FRIGATE HRV/ERV 120 (R) (EC) 24”