Installation Manual

ManualsBrandsVENTS-US ManualsCooling & Air QualityTT Series 12 3/8" Inline Mixed Flow Fan

www.ventsus.com

MIU_05-01

Bodor Vents, LLC DBA: VENTS-US

11013 Kenwood Road Cincinnati, Ohio 45242

Phone: (513)348-3853

e-mail: sales@ventsus.com

INLINE MIXED-FLOW FANS

TT 100/125/150/200/250/315

INSTALLATION GUIDE

INSTALLATION

Tools required

Pencil Drill Screwdriver Dowel (4 pcs.) Screws (4 pcs.)

MOUNTING

Fans may be mounted either vertically or horizontally. An air duct at least 40 inches long should be connected to an inlet ange in case of horizontal fan mounting; a canopy

should be installed on an inlet ange in case of vertical mounting. Outlet ange should always be connected to an air duct.

min 40 inch min 40 inch

Typical installation of the fan

Summary of content (4 pages)

PAGE 1
INSTALLATION GUIDE INLINE MIXED-FLOW FANS TT 100/125/150/200/250/315 INSTALLATION Tools required Pencil Drill Screwdriver Dowel (4 pcs.) Screws (4 pcs.) MOUNTING Fans may be mounted either vertically or horizontally. An air duct at least 40 inches long should be connected to an inlet flange in case of horizontal fan mounting; a canopy should be installed on an inlet flange in case of vertical mounting. Outlet flange should always be connected to an air duct.
PAGE 2
1) Disconnect the fan from power supply. 2) Deinstall the fixing brackets. 3) Remove the fan from the casing. 4) Mark holes on the wall. 5) Drill the holes and insert the expansion anschors. 6) Fix the fan. 7) Install the fan into the casing 8) Connect air ducts www.ventsus.com 1 2 3 4 5 6 7 8 Bodor Vents, LLC DBA: VENTS-US 11013 Kenwood Road Cincinnati, Ohio 45242 Phone: (513)348-3853 e-mail: sales@ventsus.
PAGE 3
Connection of the fan and standard wall socket HOUSE JUNCTION BOX S1 AUT OMATIC SWITCH GREEN GROUND SCREW 120vAC, 60Hz HOUSE POWER ST ANDARD WALL SOCKET FA N EAR TH GROUND MIN S TOP www.ventsus.com Bodor Vents, LLC DBA: VENTS-US 11013 Kenwood Road Cincinnati, Ohio 45242 Phone: (513)348-3853 e-mail: sales@ventsus.
PAGE 4
The fan must be connected using durable, insulated and heat-resistant cables and wires. 1) Disconnect the fan from power supply. 2) Remove the cover from the terminal block. 3) Remove the cable clamp. 4) Connect the cables according, install the cable clamp. 5) Install the terminal block cover 6) Сonnect the fan from power supply. QF 1 4 www.ventsus.com Bodor Vents, LLC DBA: VENTS-US 11013 Kenwood Road Cincinnati, Ohio 45242 Phone: (513)348-3853 e-mail: sales@ventsus.