Instructions / Assembly

ManualsBrandsVENTS ManualsGarden Center240 CFM Power 5 in. Centrifugal In-Line Ventilation Fan with Two 5 in. Inlet and One 5 in. Outlet

www.ventsus.com

MIU_15,16_VKP,VKPF-01

Bodor Vents, LLC DBA: VENTS-US

11013 Kenwood Road Cincinnati, Ohio 45242

Phone: (513)348-3853

e-mail: sales@ventsus.com

INSTALLATION GUIDE

Tools required

Pencil

Drill

Ø 6 mm

Screwdriver

Dowel 4 pcs

NTW 6/35

Screws 4 pcs

4/35

IN-LINE CENTRIFUGAL FAN

VKP 100

VKP 125

VKP 150

VKP 125/125x2

VKP 150/150x2

VKPF 100/100x2

VKPF 125/125x2

MOUNTING

Typical Fan installation

Summary of content (4 pages)

PAGE 1
INSTALLATION GUIDE IN-LINE CENTRIFUGAL FAN VKP 100 VKP 125 VKP 150 VKP 125/125x2 VKP 150/150x2 VKPF 100/100x2 VKPF 125/125x2 Tools required Pencil Drill Ø 6 mm Screwdriver Dowel 4 pcs NTW 6/35 Screws 4 pcs 4/35 MOUNTING Typical Fan installation www.ventsus.com Bodor Vents, LLC DBA: VENTS-US 11013 Kenwood Road Cincinnati, Ohio 45242 Phone: (513)348-3853 e-mail: sales@ventsus.
PAGE 2
The process of fan mounting with the use of a bracket together with four screws and dowels is shown in Fig. 1-4. 1. Mark fastening holes 2. Drill fastening holes 3. Install the casing on the mounting bracket 4. Tighten the screws The process of ventilation shaft attachment is shown on Pic. 5-6. Air flow direction should match the direction of an arrowhead placed on the fan case. 5. Connect air ducts www.ventsus.com 6.
PAGE 3
Fan connection Input: 120 V AC 60 Hz. Fans are designed for continuous operation without disconnection from network. Wiring diagram is shown on Pic.1. To connect the fan to the power network it is necessary to: - shut off the power network (Pic.2); - remove the cover from the terminal box (Pic.3); - remove the clamping bar (Pic.
PAGE 4
Fan connection only for VKPF 125/125х2 Input: 120 V AC 60 Hz. Fans are designed for continuous operation without disconnection from network. Wiring diagram is shown on Pic.6. To connect the fan to the power network it is necessary to: - shut off the power network (Pic.7); - remove the butterfly screw on the inpection cover and disconnect the inspection cover from the case (Pic.