Instructions / Assembly

ASSEMBLY

Seat and Seat Post

Attach the seat to the seat post by inserting the smaller end of the seat post

into the seat clamp and tighten. Insert the larger end of the seat post into

the seat tube of the bicycle frame observing the minimum insertion mark on

the seat post. Turn the adjusting nut of the Quick Release seat bolt to ensure

the locking lever is moved to the closed position with a firm action. Turn the

bicycle upside down and rest in on the seat and handlebars.

NOTE: Comfort bicycles may be equipped with a suspension seat post (See

Diagram-bottom left). Some suspension posts can be adjusted for stiffness

using the preload adjusting screw. Turning the 6mm Allen screw Clockwise

will decrease travel and make the suspension stiffer, while turning the

6mm Allen screw Counter-clockwise will increase travel and make the

suspension less rigid.

Note: In addition to normal assembly, please be aware that the preload

adjusting screw must be flush with the bottom of the post.

Failure to do this may cause irreparable damage.

The seat post must be inserted so that the minimum

insertion mark cannot be seen. The quick release

mechanism must be tightened securely to prevent a sudden

shift of the seat when riding Failure to do this may cause

loss of bicycle control.

Seat

Clamp

Seat

Post

Quick

Release

Adjusting

Nut

Attach

Seat Here

Boot

Minimum

Insertion

Mark

Insert this

end into

frame