User Manual

9
Additional remote thermo-hygrometer sensor:
Additional remote thermo-hygrometer sensors can be purchased separately (not supplied in the
package).
Important: Select Ch-2 or 3 for additional remote thermo-hygrometer sensor since Ch-1 has been
assigned to the anemometer.
Searching mode display:
Temperature & humidity information will flash
RF Connection completed:
Valid temperature/humidity readings of your selected channel appear
RF Connection failed:
Unable to display the temperature & humidity readings of your selected channel
WEATHER FORECAST & BAROMETRIC PRESSURE
The unit predicts weather condition of the next 12 – 24 hours based on the change of atmospheric
pressure. The coverage area is around 30 – 50 km. The weather forecast is based on atmospheric
pressure change and is about 70-75% correct. As weather conditions cannot be 100% correctly
forecasted, we cannot be responsible for any loss caused by an incorrect forecast.
SUNNY PARTLY CLOUDY CLOUDY RAINY STORMY
To obtain an accurate weather forecast & barometric pressure reading, you need to input your current
local sea level pressure. After battery/adapter installation, it will enter sea level pressure setting directly
and the pressure reading will flash. Press “▲” or “▼” to set the value and press “PRESSURE” to
confirm and exit.
You can also hold “PRESSURE” button to enter sea level pressure setting in normal display mode.
Press “▲” or “▼” to set the value and press “PRESSURE” to confirm and exit.
Press PRESSURE button to select pressure unit between hPa, inHg & mb.
Note: you may obtain your current local sea level pressure information from the weather web site.
IN/OUT TEMPERATURE & HUMIDITY
Temperature & humidity readings are shown on the upper right of the display.
Press “C/F“ button to select temperature unit C/ F.
Press “CHANNEL/SEARCH” repeatedly to select indoor, Ch1, Ch2, Ch3 or auto-channel scrolling
display modes.