User guide

• Set up the sensor features.
• Insert the sensor.
• If you are using the Enlite Sensor (MMT-7008), wait five minutes. If you are using a different sensor
(MMT-7002/MMT-7003), wait 10–15 minutes.
• Connect the transmitter to the sensor.
• Start the sensor and wait two hours.
• Enter your first meter BG.
Inserting the Enlite sensor
This procedure shows you how to insert the Enlite Sensor (MMT-7008) using the Enlite Serter (MMT-7510). If
you are using a different sensor (MMT-7002 or MMT-7003), use the insertion instructions in the sensor user
guide.
CAUTION: Healthcare professionals and caregivers should wear gloves when handling the sensor.
1 Wash your hands.
2 Select an insertion site.
3 Clean the insertion site with alcohol. Allow the area to air–dry.
4 Open the sensor package.
5 Remove the pedestal from the package. Place the pedestal on a flat surface.
6 Push the Serter down onto the pedestal until the base of the Serter sits flat on the table.
Sensor features132