User manual

Page 7 of 65

Camera Setup

Before installing the Veo Observer Camera, you should have an available Ethernet

LAN connection (RJ-45 port). To view the camera’s image or make any manual

configuration changes, you will need a Windows PC with Internet Explorer 5.0 or

higher, also connected to the LAN.

2.1 Hardware Setup

Connecting the Ethernet cable

Connecting the power adapter

Chapter

CAUTION: Make sure to only use the power

adapter supplied with your Veo Observer

Network Camera. Using a non-approved power

adapter may damage the camera.

Step 1

. Plug the included Ethernet cable into the RJ

45 connector at the back of the camera as shown.

Step 2

. Plug the other end of the Ethernet cable into

any available LAN port. A typical home

router/gateway connection is shown on the left.

Step 3

. Connect the power supply to the back of the camera as

shown, and then plug the supply into an available power outlet.