Operating instructions

Charged Aerosol Detectors
Corona Veo and Corona Veo RS
Page 118 Operating Instructions
8.8 Replacing the Main Power Fuses
Warning: Turn off the main power switch. Disconnect the power cord from its
source.
Avertissement: Avant de remplacer les fusibles, arrêtez le détecteur. Assurez-vous
de bien débrancher le cordon d'alimentation de la source secteur.
1. Remove the fuse cartridge, using a small screwdriver.
Fig. 26: Fuse cartridge
2. Replace the two fuses.
Warning: Always install two fuses. Use only the fuses indicated in the
following table.
Avertissement: Installez toujours deux nouveaux fusibles. Utilisez
uniquement les fusibles indiqués ci-dessous.
Description Part no.
Fuse, 1A, slow-blow (5 x 20 mm) Included in Fuses Kit (part no. 70-6666)
For information about the kit, see section 10.3
(→ page 127).
3. Reinstall the fuse cartridge.
4. Reconnect the power cord to its source. Turn on the power to the detector.
Fuse cartridge