Operating instructions

Charged Aerosol Detectors
Corona Veo and Corona Veo RS
Operating Instructions Page 29
3.4 Connecting the Detector Rear Panel
3.4.1 Overview of Connections
The rear panel connections depend on the system configuration. The following overview is
to assist you with the required connections:
• USB connection
Connect the USB port to
♦ Use the detector with other system modules, such as UltiMate 3000 modules.
– and/or –
♦ Connect the detector to a data system computer via USB port and operate it from
chromatography software, such as Chromeleon.
• Digital I/O connection
Connect the Digital I/O port to
♦ Connect a pump to the detector within an HPLC system, such as the UltiMate 3000
system, and establish the 'Pump Off' connection.
– and/or –
♦ Connect the detector to other external devices.
• Analog signal output connection
Use and install the analog signal output to use the detector with a data system computer if
no USB port is available on the computer.
3.4.2 Connecting the Power Cord
Use the power cord shipped with the device to connect the detector to the main power
source. Connect the power cord from the main power receptacle on the rear panel. No
manual adjustment is required to adapt the line voltage to local voltage requirements.
Warning: Never use a power cord other than the power cords provided for the
device.
Do not use defective multiple sockets or extension cords, as they
may cause personal injury or damage to the device.
Avertissement: Utilisez uniquement les cordons d’alimentation électrique spécifique
à l’instrument.
N'utilisez pas des défectueux blocs multiprise ou des câbles
prolongateurs. Cela pourrait entraîner des blessures corporelles ou
endommager l'instrument.