Operating instructions

Charged Aerosol Detectors
Corona Veo and Corona Veo RS
Operating Instructions Page 83
• Device Name
Displays the name used to identify the detector the installation environment and in the
Chromeleon client program. To control the detector with the existing control panels,
accept the default name. If you enter a different name, you may have to re-link the
controls on the control panels and edit the device name in the program files.
Signals Page
The page lists all signal channels that Chromeleon can record for the detector. The signal
type and name of each signal is displayed. To allow raw data collection for a signal, select
the Enabled check box next to the signal name. If the check box is cleared, the detector
cannot collect raw data for the signal. To change a signal name, overwrite the existing
name directly in the Name line.
If the signals are renamed during the configuration, it is also necessary to update the panel
tabset.
Fig. 19: Signals page (here: Corona Veo RS)
Relays Page
The Relays page lists all available relays. They refer to the relay outputs CC1 and CC2 on the
rear panel of the detector.
The 'Pump Off' output is not available in Chromeleon.
To have the relays available for control on the detector tabset panel in Chromeleon, select a
check box. If a check box is cleared, the relay will not be available on the detector tabset
panel. To change a relay name, overwrite the existing name directly in the corresponding line.
Fig. 20: Relays page