Operating instructions

Charged Aerosol Detectors
Corona Veo and Corona Veo RS
Page 84 Operating Instructions
6.1.3.2 Changing the Configuration Properties
You may reopen the configuration pages later again to change the settings.
1. Start the Server Configuration program (→ page 80).
2. Right-click the Corona Veo Charged Aerosol Detector in the timebase and click
Properties on the menu.
3. Change the settings as needed. For a description of the pages, see section 6.1.3.1
(→ page 81).
4. To save the changed configuration, click Save on the File menu and then close the
Server Configuration program.
6.2 Setting Up the Detector in DCMSLink
To set up the detector in DCMSLink, refer to DCMSLink Installation Guide, which is
provided on the DCMSLink DVD in the Additional Documents\DCMSLink User
Documents folder.
1. Install and configure the DCMSLink software (→ DCMSLink Installation Guide).
2. Open the Chromeleon Server Configuration program (→ DCMSLink Installation
Guide).
3. In the Server Configuration program, add the detector to the timebase. Follow the
appropriate steps in section 6.1.2 (→ page 80).
4. Configure the detector as described in section 6.1.3 (→ page 81).
For more information about DCMSLink, refer to the DCMSLink Quick Start Guide, which
is also provided on the DCMSLink DVD and to DCMSLink Help.