Installation & Assembly

Screen Set
ASSEMBLY Instructions
Parts
Step 1
Attach Stand Foot to
Stand Riser - Long using
4 nuts and 4 bolts.
Tighten using pliers and
Allen Key. Repeat for
second Stand Foot and
second Stand Riser –
Long.Long.
Step 3
Slide second Screen Panel
into channel of assembled
stand. Ensure the panel is
placed in the channel with
the narrow end of side holes
facing up. Note – panel may
fit tightly and may require a
rubber mallet to nudge the rubber mallet to nudge the
panel into place. Hand
tighten using 4 nuts and 4
bolts (bottom holes
connected to stand only).
Step 5
Slide last Screen Panel with Stand
Riser Bar – Short onto Screen
Panel – Middle Piece. Note –
panel may fit tightly and may
require a rubber mallet to nudge
the panel into place. Install
remaining nuts and bolts.
Step 4
Attach Stand Riser Bar –
Short to last Screen Panel as
shown using 2 nuts and 2
bolts. Repeat with second
Stand Riser Bar – Short.
Hand tighten only.
Step 6
Tighten remaining nuts and bolts using pliers and allen
key.
NOTES - Multiple assembled sets can be bolted together
- A rubber mallet or hammer may be required to
nudge panels into place.
TOOLS REQUIRED - Pliers, Allen Key
Step 2
Attach Screen Panel to
first assembled Stand
Riser Bar – Long using 2
nuts and 2 bolts. Make
sure the panel is placed
in the channel with
narrow end side holes
facing up (as shown). facing up (as shown).
Repeat with second
Assembled Riser Bar.
Hand tighten only.
Narrow end
facing up
Narrow end
facing up
Panel side view before assembly
Assembled Panel
Stand
Foot
Screen Panel
x 3
Nuts &
Bolts
Stand Riser Bar - Short
Stand Riser Bar - Long