Installation Guide

ManualsBrandsVeranda ArmorGuard ManualsLumber & Composites1.25 in. x 3.5 in. x 0.5 ft. Capped Composite Deck Railing Sample in Brazilian Walnut

1

2

3

4

Predrill holes at 1/3 points and between the

bracket and rst baluster from each end

using a 1/8” drill bit.

Follow up with a 7/32” drill bit, drilling

through the top sub rail only (this will allow

screws to snug the top rail tightly).

Finish by gluing the post caps on using a

quality exterior adhesive.

Cut 1 crush block from baluster and glue

centered between posts as shown in the

above diagram.

Secure the top rail to the top sub rail using

four 1-3/4” screws (hardware sold separately).

(NOTE: It may be necessary to countersink

using a 3/8” bit, not more than 1/4” deep.)

www.verandadeck.com

15 16 17

VER-0057-LIT 7/13