Installation Guide

ManualsBrandsVeranda ManualsLumber & CompositesPro Series 6 ft. x 5 ft. Anaheim White Cedar Privacy Single Walk Through Arched Top Vinyl Fence Gate

GATES

Installation Tips

Planning

• Priortoconstruction,checkwithyourlocalregulatoryagencyforspecialcoderequirementsinyourarea.

• Contactyourutilitysuppliertolocateandmarkundergroundlines.

• Carefulplanningandmeasuringofyourfenceprojectisessential,asmovingpostsaftertheconcretesetsisextremelydifficult.

Digging Post Holes

• Digpostholeforthehingepost18”to24”indiameterand36”to42”deep(dependingonlocalordinanceorexpectedfrostdepthin

 winter).Werecommendthatyouinsertapieceof4x4treatedlumbertosupportthegatehingepost.Seefig.1.

• Checkmeasurementofgate.Actualwidthofgateis41-1/2”.Theinsidepost-to-postdimensionis42-3/4”Thiswillgiveyou5/8”

 gaponbothsidesofthegatetotheposts.Double-check all measurements!

Setting and Installing Gate

• Measuretobesureyoucaninstallthegatetothepostwith

 approximatelya2”gapfromthegroundtothebottomofthe

 panel.Aligntherailsonthegatetotherailsonthepanels.

• Hangthepre-assembledpanelbetweentheposts.Usea5/8”

 spacerbetweenthegatesandtheposts.Seefig.2.Securein

 placewithshimsunderthegateorclampthejambonthegate

 tothepost.Makesurethegateislevelandsquare.Attachhinge

 platestothegatepostwiththeprovidedscrews.Seefig.3.

• Removeanyclampsandshims.Attachlatchusingscrews

 provided.Seefig.4.

• InstallapostcaponeachpostusingPVCcementoran

 exterioradhesive.

Customer Service877-463-8379

www.verandavinylfencing.com

Thediagramsandinstructionsshownareforillustrationpurposesonlyandarenotmeanttoreplacealicensedprofessional.Anyconstructionoruseoftheproductmustbeinaccordancewithalllocalzoningand/or

buildingcodes.Theconsumerassumesallrisksandliabilityassociatedwiththeconstructionoruseofthisproduct.Theconsumerorcontractorshouldtakeallnecessarystepstoensurethesafetyofeveryoneinvolved

intheproject,including,butnotlimitedto,wearingtheappropriatesafetyequipment.EXCEPTASCONTAINEDINTHEWRITTENLIMITEDWARRANTY,THEWARRANTORDOESNOTPROVIDEANYOTHER

WARRANTY,EITHEREXPRESSORIMPLIED,ANDSHALLNOTBELIABLEFORANYDAMAGES,INCLUDINGCONSEQUENTIALDAMAGES.

MadeinCanada

fig. 3

fig. 4

fig. 1

fig. 2

Summary of content (2 pages)

PAGE 1
GATES Installation Tips Planning • Prior to construction, check with your local regulatory agency for special code requirements in your area. • Contact your utility supplier to locate and mark underground lines. • Careful planning and measuring of your fence project is essential, as moving posts after the concrete sets is extremely difficult. Digging Post Holes • Dig post hole for the hinge post 18” to 24” in diameter and 36” to 42” deep (depending on local ordinance or expected frost depth in winter).
PAGE 2
PUERTAS Consejos de instalación Planificación • Antes de comenzar la construcción, compruebe con su agencia reguladora local cualquier requisito especial en su área • Contáctese con las compañías de servicios públicos para localizar y marcar las líneas subterráneas. • Es esencial una planificación y medición cuidadosa de su cerca, puesto que mover los postes después de que el concreto se ha asentado es extremadamente difícil.