Instructions / Assembly

5
7
7
8
8
Remove clamped stair kit from posts. Locate previous
marked rails and add 1" to your pre-determined
measurement (Fig A). Cut all four 1" marks on rails at
90 degrees (Fig B).
Note: There is a separate screw pack for the top rail
brackets and the bottom rail brackets.
a. Slide your angle brackets top/bottom onto your
rails and place stair rail section between your posts.
b. Determine desired rail height and mark all bracket
holes.
c. Pre-drill all bracket holes.
d. Position drill bit on center of post (2" from either
side) and between previously drilled four screw
holes. Pre-drill using 1/8" drill bit all the way through
steel insert.
e. Attach 2" screw into post all the way through steel
insert.
f. Add screws to mount brackets to posts. For top rails,
make sure to use 2" self tapping screws.
g. Pre-drill each side of the top rail brackets using the
screw holes provided. Use provided screws and caps
to complete the installation.
a.
b.
b.
b.
a.
c.
f.
b.
b.
b.
d.
d.
d.
e.