Installation Guide

1.800.336.2383 www.barretteoutdoorliving.com
ALUMINUM FENCE
INSTALLATION
1. Use a rubber mallet to drive the
post top tops onto the posts. Be
careful not to damage the post top.
Starting with an End Post or Gate
Post, Insert fence section into holes in
post. Fence sections must be inserted
all the way inside post holes to meet
BOCA code.
2. Fill the post hole with concrete
mix being sure the concrete extends
below the bottom of post.
3. Plumb the posts and pickets while
the concrete is setting. The fence
section can rack allowing the rails
to follow the contour of the ground.
Brace the posts as necessary while
the concrete is setting.
4. Fence rails will need to be mitered
for corner posts.
5. After concrete has set, fasten the
fence section to the posts using #8 x
1” self-tapping screws.
Be careful not to over-tighten to avoid
screw heads from breaking
off or stripping out.
Notched Post Installation
AFENCE/V.1/11-11