Installation Guide

5.1: Plug in top brackets to chassis with "This Side Up" facing up to the top.

5.2: Attach the bracket to the chassis with a supplied #8 x 5/8" self tapping

screw in groove in chassis. Repeat on opposite side. (NOTE: For 10' rail

kits, chassis will be made of aluminum and should be pre-drilled with

1/8" drill bit.)

5.3: Turn chassis upside down and lay baluster spacer on top of chassis.

Make sure the baluster spacer completely covers the chassis and

brackets without extending beyond ends of brackets.

5.4: Install baluster plugs through baluster spacer into the chassis until you

hear a snap.

5.5: Carry assembled top rail chassis and plugs over to rail section and slide

baluster plugs into the top of the previously installed balusters. Align

plugs partially into each baluster. After all are engaged, ﬁ rmly push

down to ensure balusters fully engage the baluster plugs and the top

baluster spacer becomes tight to the chassis.

5.7: Pre-drill with a 13/64" drill bit from the top

of the installed chassis down all the way

through baluster spacer cover. Start on

one side of ﬁ rst bracket in corner nooks as

indicated. For 6' rails, install two screws

per bracket and two additional screws

at midway point between brackets and

chassis. Be sure to drill directly through the

scored lines on the top of chasses. For 8'

rails, install two screws per bracket, and

remaining four screws equally spaced.

5.6: Using supplied #10 x 2-1/2" screws, attach top brackets to center of

post. (NOTE: Be sure to push down on top of chassis while screwing

into post to make the ﬁ t "snug")

Prepare the Top Rail

6' Rail

8' Rail

Drill on scored lines

Evenly space the screws