Installation Guide

ManualsBrandsVeranda ManualsDecor Screws1-1/2 in. Stainless Steel Nantucket Gray Screws (12-Piece/Bag)

INSTALLATION INSTRUCTIONS

Plastic Lattice

VERANDA-WEB

Read all instructions prior to installing product.

Refer to manufacturers safety instructions when operating any tools.

To register your product, please visit:

veranda.barretteoutdoorliving.com

Summary of content (5 pages)

PAGE 1
VERANDA-WEB Plastic Lattice INSTALLATION INSTRUCTIONS Read all instructions prior to installing product. Refer to manufacturers safety instructions when operating any tools. To register your product, please visit: veranda.barretteoutdoorliving.
PAGE 2
WARNING: • Improper installation of this product can result in personal injury. Always wear safety goggles when cutting, drilling and assembling the product. • Incorrect installation may cause harm to the product or individual. • Not for horizontal installations. NOTICE: • DO NOT attempt to assemble the kit if parts are missing or damaged. • DO NOT return the product to the store, for assistance or replacement parts call: 1-800-336-2383.
PAGE 3
INSTALLING WITHOUT MOULDINGS: 1 Pre-drill oversized holes through lattice (drill the largest hole that screw head will allow without fitting though) (Fig. 1). Center each screw in oversized holes a nd do not overtighten to allow for expansion and contraction of lattice (Fig. 2). Fig. 1 Lattice Wood Fig. 2 2 Hang the lattice with a screw every 24". Attach sides and bottom loosely. DO NOT tighten all the way (Fig. 3). Fig. 3 3 If using more than one panel, do not butt panels together (Fig. 4).
PAGE 4
INSTALLING WITH CAP & DIVIDER MOULDINGS: 1 Pre-drill oversized holes through lattice and moulding (drill the largest hole that screw head will allow without fitting though) (Fig. 1). Center each s crew in oversized holes and do not overtighten to allow for expansion and contraction of lattice (Fig. 2). Fig. 1 Molding Lattice Wood Fig. 2 3 Along the sides and bottom, drill holes and put screws through moulding only (Fig. 4). Fig.
PAGE 5
IMPORTANT THINGS TO REMEMBER: • If the lattice bows, loosen attaching screws, make sure you have allowed enough gap for expansion and contraction. • Place screws 24" apart. 24" • DO NOT use for horizontal Installation.