Installation Guide

3
1.
2.
Mark the fence location using string and line
stakes (Fig. 1).
NOTE:
Plan gate placement, opening and hardware
clearance before installing fencing.
a. Dig the  rst two post holes. Hole size should
be dug based on the following determination:
Depth is determined by your local frost line
measurements plus 6" for gravel/ ller (Fig. 2).
Width is determined by the post size.
See chart below for measurements.
Diameters based on post size:
10" for 5" x 5" post
8" for 4" x 4" post
b. Insert 6" of gravel/ ller into the bottom of
both holes and then set the  rst post into the
ground and level it.
c. Add wet or dry concrete mix according to
manufacturer's instructions to the top of
the  rst post hole only and assure your post
remains level (Fig. 3).
Fig. 1
Fig. 2
5x5 Post
Example:
Frost
Line
Gravel/
Filler
6"
10"
Fig. 3
Post
Concrete
Gravel/Filler