Vinyl Fence Framed Gate Kits 34107025BOM V1 1/14 Owner's Manual Assembly and Installation Instructions PLEASE READ OWNER'S MANUAL COMPLETELY BEFORE ASSEMBLING YOUR GATE. Privacy Gates To register your product, please visit: www.barretteoutdoorliving.com/product-registration Version 1.
Thank you for choosing the Barrette Outdoor Living Fence Gate. Please read the instructions completely before assembling your gate. Retain manual and your dated sales slip for future reference and warranty claims. Material Checklist: Phillips Head Screwdriver Tape Measure Check your local zoning laws. Safety Glasses Drill • Local zoning laws and Home Owners Associations may regulate the location, style and height of your fence or even require a permit signoff beforehand.
Closed Top Picket Gate Pockets Internal Post Top Side Channels Top Rail Middle Rail Bottom Rail Gate Upright Open Top Picket Gate Pockets Internal Post Top Side Channels Top Rail Middle Rail Bottom Rail Gate Upright
Installation 1.) Insert aluminum inserts into both gate uprights. 2.) In the gate kit there will be two boards that are 41⁄8" wide, make sure these boards are your end boards and add left and right u-channels onto the ends of these two gate boards. Make sure one u-channel is on the “groove” side of the board and one u-channel is on the “tongue” side of the board. 3.) Insert bottom rail into bottom upright route on one side only. 4.
7.) Ensure gate is square. Measure from top left corner to bottom right corner and write down the measurement. Measure from top right corner to bottom left corner and write down the measurement. Make sure measurements are equal before installing screws into uprights. 8.) a.) Once gates are square mark screw locations. Make sure to use measurements below to mark holes for screws. b.
9.) Using 1/8" drill bit pre-drill screw holes through uprights, aluminum inserts and rails. Install 1" screws into all pre-drilled screw holes. 10.) Install upright caps onto gate uprights. 11.) Install hinges according to hinge instructions for privacy gates; make sure hinges are centered between the screws. For all gates, make sure hinges are installed on upright on the opposite side of the “leg” of the aluminum insert.
Limited Lifetime Warranty Subject to the conditions and limitations set out below, Barrette Outdoor Living warrants that for so long as the original purchaser of a product manufactured by Barrette Outdoor Living owns that Boerboel Manual Hardware (the Product) it will be free from all defects due to faulty design, materials or workmanship.
Transferable Limited Lifetime Warranty What is covered: Barrette Outdoor Living warrants vinyl and aluminum products to include; vinyl and aluminum fence, vinyl and aluminum railing and plastic lattice against defects or workmanship for as long as you own your home. Barrette Outdoor Living will at its option replace the product in question with new product of the same or equivalent value at no charge.
